Rust-Oleum Automotive 251572 Gebrauchs- und Pflegehandbuch
Stöbern Sie online oder laden Sie Gebrauchs- und Pflegehandbuch nach Nein Rust-Oleum Automotive 251572 herunter. Rust-Oleum Automotive 251572 Use and Care Manual Benutzerhandbuch
- Seite / 2
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
TECHNICAL DATA ATO-01
AUTOMOTIVE
ADHESION PROMOTER
Form: GDH-418
Rev.: 081814
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Adhesion Promoter is a fast drying, clear primer to
promote adhesion to polyolefin surfaces such as automotive
plastics, vinyl, trim, bumpers, fiberglass, and more. Rust-Oleum
®
Adhesion Promoter features an advanced spray system that
allows you to spray at any angle, even upside down for those
hard to reach areas. A comfort spray tip with a wider finger pad
reduces fatigue caused by continuous spraying.
.PRODUCTS .
SKU Description
251572 Clear
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F and 90°F (10-
32°C) and humidity is below 85% to ensure proper drying. Do
not apply to surfaces, when heated, exceed 200°F (93°C). Avoid
spraying in very windy and dusty conditions. Cover surrounding
area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Clean area to be primed with mineral spirits to
remove all oil, grease, wax, and dirt. Remove loose paint with a
wire brush or sandpaper. Lightly sand glossy surfaces. Wipe the
sanded surface clean when finished.
WARNING: If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log onto
www.epa.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 12-16" from the surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. For best results,
apply 2 or more light coats a few minutes apart. Do not
use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 10 minutes and dries to handle in 15-30 minutes.
A topcoat must be applied within 10 minutes after primer
application. For best results apply a finish coat of
Rust-Oleum Automotive finish.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.
1
2
Inhaltsverzeichnis
Seite 1 - ADHESION PROMOTER
TECHNICAL DATA ATO-01 AUTOMOTIVE ADHESION PROMOTER
Seite 2 - AUTOMOTIVE ADHESION PROMOTER
TECHNICAL DATA AUTOMOTIVE ADHESION PROMOTER Rust-Oleum Corporation
Verwandte Produkte und Handbücher für Nein Rust-Oleum Automotive 251572
(2 Seiten)Candy LB CTS 45 T UNI manuales
Manuales del propietario y guías del usuario para Arandelas Candy LB CTS 45 T UNI.
Ofrecemos 1 manuales en pdf Candy LB CTS 45 T UNI para descargar gratis por tipos de documentos: Manual de usuario
Kommentare zu diesen Handbüchern